Installation

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat):

INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT SEAT ASSEMBLY LH
(a) Install the front seat.

NOTE: Be careful not to damage the vehicle body.

(b) Connect the seat wire connectors under the seat.
(c) Operate the seat track adjusting handle to move the seat to the rearmost position.





(d) Install the 2 bolts.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
(e) Operate the seat track adjusting handle to move the seat to the foremost position.





(f) Install the 2 bolts.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
2. INSTALL OUTER FRONT SEAT TRACK COVER LH REAR





(a) Attach the 2 claws to install the seat track cover.





3. INSTALL INNER FRONT SEAT TRACK COVER LH REAR
Attach the 2 claws to install the seat track cover.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

5. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (Diagnosis System).