Installation

AXLE: STEERING KNUCKLE:

INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD)





(a) Using a brass bar and hammer, tap in a new retainer cap.

- The retainer cap is a non-reusable part.
- Do not damage the retainer cap.

2. INSTALL STEERING KNUCKLE OIL SEAL LH





(a) Using SST and a press, press in a new oil seal.
SST: 09950-60020
09951-01030
SST: 09950-70010
09951-07100

- The oil seal is a non-reusable part.
- Do not damage the steering knuckle oil seal.

3. INSTALL STEERING KNUCKLE LH
(a) Install the front suspension upper arm to the steering knuckle with the nut.
Torque: 110 Nm (1,122 kgf-cm, 81 ft-lbf)
(b) Install a new clip.

HINT: If the holes for the clip are not aligned, tighten the nut up to another 60°.

4. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH (Installation)

5. CONNECT TIE ROD END SUB-ASSEMBLY LH (Installation)

6. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
(a) Install the front axle hub (Installation).
7. CONNECT FRONT SPEED SENSOR LH





(a) Connect the front speed sensor to the steering knuckle with the bolt.
Torque: 11 Nm (107 kgf-cm, 8 ft-lbf)
(b) Attach the clip to the steering knuckle.
8. INSTALL FRONT WHEEL
for Aluminum Wheel - Torque: 131 Nm (1336 kgf-cm, 97 ft-lbf)
for Steel Wheel - Torque: 209 Nm (2131 kgf-cm, 154 ft-lbf)
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

10. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal (Test Mode Procedure).
11. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (Diagnosis System).
12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment (Service and Repair).