Audio and Visual System (for Regular Cab and Double Cab)

AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab): 01-DC: Transmission Error

DTC 01-DC - Transmission Error

DESCRIPTION





HINT: *: This code may be stored if the engine is started, idled for 60 seconds and then the ignition switch is turned to the START position again.

NOTICE:
- Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The radio receiver is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.

INSPECTION PROCEDURE

NOTE: Be sure to read the DESCRIPTION before performing the following procedures.

PROCEDURE

1. CHECK FOR DTC OF OTHER COMPONENTS
(a) Check if the component shown by the sub-code is displayed in the check result of the other components.
(1) Check if "01-DC" is output for the other components.
(2) If "01-DC" is output for any other components, check if the same physical address is displayed.

HINT: For the list of the components shown by sub-codes, refer to the table in the next step.

Result:





B -- IDENTIFY COMPONENT WHICH HAS STORED THIS CODE
A -- Continue to next step.
2. CLEAR DTC
(a) Clear the DTCs (Audio and Visual System (for Regular Cab and Double Cab)).

HINT: If "01-DC" is output for only one component, this may not indicate a malfunction.

NEXT -- Continue to next step.
3. RECHECK DTC
(a) Recheck for DTCs and check if the same trouble occurs again.
OK:
Malfunction disappears.
NG -- CHECK COMPONENT WHICH HAS STORED THIS CODE
OK -- END
4. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE
(a) Enter the diagnostic mode.





(b) Press the preset switch "3" to change to "Detailed Information Mode".
(c) Identify the component which has stored this code.

Component table:





HINT:
- "440 (stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.

- For details of the DTC display, refer to "DTC CHECK/CLEAR" (Audio and Visual System (for Regular Cab and Double Cab)).

NEXT -- Continue to next step.
5. CHECK COMPONENT WHICH HAS STORED THIS CODE
(a) Select the component which has stored this code.

Component table:





NEXT -- END