Park / Neutral Position Switch Circuit
PARK ASSIST / MONITORING: INTUITIVE PARKING ASSIST SYSTEM: Park / Neutral Position Switch Circuit
Park / Neutral Position Switch Circuit
DESCRIPTION
This circuit sends the park / neutral position switch signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. INSPECT PARK / NEUTRAL POSITION SWITCH
(a) Disconnect the D35 switch connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Result
C -- REPLACE PARK / NEUTRAL POSITION SWITCH
B -- REPLACE PARK / NEUTRAL POSITION SWITCH
A -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (SWITCH - CLEARANCE WARNING ECU AND BATTERY)
(a) Disconnect the D35 switch connector.
(b) Disconnect the J35 ECU connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard voltage:
(d) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE