CD Cannot be Inserted Or Is Ejected Right After Insertion

NAVIGATION: NAVIGATION SYSTEM (for CrewMax): CD cannot be Inserted or is Ejected Right After Insertion

CD cannot be Inserted or is Ejected Right After Insertion

INSPECTION PROCEDURE

PROCEDURE

1. CHECK IF PROPER CD IS INSERTED
(a) Make sure that the CD is an audio CD or a CD with a MP3 or WMA file, and that the CD is not deformed, flawed, stained, burred or otherwise defective.
OK:
CD is a normal audio CD.
HINT:
- Translucent or uniquely-shaped CDs cannot be played.
- Commercial audio CDs can be played.
- CD-DA files on CD-ROMs, CD-Rs, and CD-RWs can be played.
- MP3 and WMA files on CD-ROMs, CD-Rs and CDRWs can be played.
- For details on playable CDs, refer to the Owner's Manual.

NG -- CD IS FAULTY
OK -- Continue to next step.
2. CHECK THAT CD IS INSERTED PROPERLY
(a) Check whether or not the CD is inserted upside down.
OK:
CD is properly inserted.
NG -- INSERT CD PROPERLY
OK -- Continue to next step.
3. CLEAN CD





(a) Clean the disc by wiping the CD's underside radially with a soft cloth.
OK:
Malfunction disappears.
NOTE: Do not use a conventional record cleaner or antistatic preservative.

NG -- REPLACE CD WITH ANOTHER AND RECHECK
OK -- CD WAS DIRTY
4. REPLACE CD WITH ANOTHER AND RECHECK
(a) Replace the CD with a normal one and check if the same problem occurs again.
OK:
Malfunction disappears.
NG -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK -- CD IS FAULTY