Disassembly

PARKING BRAKE ASSEMBLY:

DISASSEMBLY

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL LH
2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH





(a) Remove the 2 bolts and disconnect the rear disc brake cylinder.

- Do not disconnect the flexible hose from the disc brake cylinder.
- Do not twist or bend the flexible hose.

(b) Hang the disc brake cylinder with a piece of wire.
3. REMOVE REAR DISC (Removal)

4. REMOVE PARKING BRAKE SHOE RETURN SPRING





(a) Using SST, remove the return spring.
SST: 09703-30011
5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH





(a) Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.
SST: 09718-00011
(b) Disconnect the tension spring from the No. 1 parking brake shoe.
(c) Remove the No. 1 parking brake shoe and shoe adjuster screw set.
6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH





(a) Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.
SST: 09718-00011
(b) Remove the No. 2 parking brake shoe.
7. REMOVE PARKING BRAKE SHOE LEVER LH





(a) Disconnect the No. 3 parking brake cable from the parking brake shoe lever.
(b) Remove the parking brake shoe lever.
8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY





(a) Remove the bolt and No. 3 parking brake cable.
9. REMOVE PARKING BRAKE ANCHOR BLOCK





(a) Remove the 2 nuts and anchor block.