Inspection

2UZ-FE ENGINE CONTROL SYSTEM: MASS AIR FLOW METER:

INSPECTION

1. INSPECT MASS AIR FLOW METER





(a) Check the output voltage.
(1) Apply battery voltage across terminals 1 (+B) and 2 (E2G).

NOTE: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

(2) Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG), and negative (-) tester probe to terminal 2 (E2G).
(3) Blow air into the MAF meter, and check that the voltage fluctuates.
If the result is not as specified, replace the MAF meter.
(b) Check the IAT sensor.





(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the result is not as specified, replace the MAF meter.