Removal

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR (for Regular Cab):

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side) (Disassembly)

3. REMOVE FRONT ARMREST BASE PANEL UPPER LH (for Front Side) (Disassembly)

4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (for Front Side) (Disassembly)

5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (for Front Side) (Disassembly)

6. REMOVE COURTESY LIGHT ASSEMBLY (for Front Side) (Disassembly)

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) (Disassembly)

8. REMOVE FRONT SIDE AIRBAG SENSOR





(a) Disconnect the connector.
(b) Remove the screw and side airbag sensor.
9. REMOVE FRONT DOOR SCUFF PLATE LH (for Rear Side) (Removal)

10. REMOVE REAR SIDE AIRBAG SENSOR





(a) Remove the bolt and side airbag sensor from the body.
(b) Disconnect the connector.