Flex Plate

DRIVE PLATE AND RING GEAR SUB-ASSEMBLY





Install and uniformly tighten 8 new bolts in the sequence shown in the illustration.
Torque 30 Nm (306 kgf-cm, 22 ft-lbf)


- Do not reuse the flywheel installation bolts.
- Do not impact or damage the flywheel installation bolts. Be sure to handle them carefully.





Mark the upside of each flywheel installation bolt with paint.
Retighten the flywheel installation bolts by 90° as shown.
Check that the painted marks are now at a 90° angle to the upside.