Installation

BRAKE: REAR BRAKE:

INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL REAR DISC





(a) While aligning the matchmarks, install the rear disc.
2. ADJUST PARKING BRAKE SHOE CLEARANCE (Reassembly)

3. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH
(a) Install the boot to the rear disc brake cylinder mounting.

NOTE: Install the boot securely to the grooves of the rear disc brake cylinder mounting.





(b) Install the rear disc brake cylinder mounting with the 2 bolts.
Torque: 95 Nm (969 kgf-cm, 70 ft-lbf)
4. INSTALL REAR DISC BRAKE PAD SUPPORT PLATE

NOTICE:
- The pad support plates can be reused if they are securely attached to the cylinder mounting. Therefore, do not remove the pad support plates from the cylinder mounting.
- If a pad support plate is removed, replace it with a new one that is supplied with double-sided tape already attached.
- Make sure to clean the cylinder mounting contact surface before attaching the pad support plates.

(a) Clean the cylinder mounting surface where the pad support plates will be attached.
(b) Remove the peeling paper from the double-sided tape, and install 4 new pad support plates to the cylinder mounting.
5. INSTALL PAD WEAR INDICATOR PLATE
(a) Install the pad wear indicator plate on the inner side disc brake pad.
6. INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
(a) Install the anti-squeal shims on each brake pad.

NOTE: There should be no oil or grease on the friction surfaces of the brake pads and the rear disc.

7. INSTALL REAR DISC BRAKE PAD KIT
(a) Install the 2 disc brake pads to the disc brake cylinder mounting.

NOTICE:
- When installing the pads, make sure that the disc brake pad support plates are securely attached to the cylinder mounting. The pad support plates are attached to the cylinder mounting with double-sided tape.
- If a pad support plate is not securely attached to the cylinder mounting, replace it with a new one.

8. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH
(a) Apply lithium soap base glycol grease to the sliding part of the 2 slide pins.





(b) Install the 2 slide pins.
Torque: 88 Nm (897 kgf-cm, 65 ft-lbf)
9. CONNECT REAR FLEXIBLE HOSE LH





(a) Install a new gasket and connect the flexible hose with the union bolt.
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
10. FILL RESERVOIR WITH BRAKE FLUID (Service and Repair)

11. BLEED AIR FROM BRAKE MASTER CYLINDER (Service and Repair)

12. BLEED AIR FROM BRAKE LINE (Service and Repair)

13. BLEED AIR FROM VSC ACTUATOR ASSEMBLY (Service and Repair)

14. CHECK BRAKE FLUID LEVEL IN RESERVOIR (Testing and Inspection)

15. CHECK FOR BRAKE FLUID LEAK
16. INSTALL REAR WHEEL
for Aluminum Wheel - Torque: 131 Nm (1336 kgf-cm, 97 ft-lbf)
for Steel Wheel - Torque: 209 Nm (2131 kgf-cm, 154 ft-lbf)