Installation

3UR-FE ENGINE MECHANICAL: DRIVE BELT:

INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT





(a) Set the V belt onto every part.
(b) While turning the belt tensioner counterclockwise, remove the pin.

NOTE: Make sure that the V belt is properly set to each pulley.

(c) After installing the belt, check that it fits properly in the ribbed grooves.

HINT: Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

2. INSTALL NO. 1 ENGINE UNDER COVER (Replacement)

3. INSTALL V-BANK COVER SUB-ASSEMBLY (Installation)