Camshaft Bearing
CAMSHAFT HOUSING SUB-ASSEMBLY RHNOTICE:
- Remove any oil from the contact surface.
- Install the camshaft housing within 3 minutes and tighten the bolts within 15 minutes after applying seal packing.
- Do not start the engine for at least 2 hours after the installation.
Install the camshaft housing, and install the 18 bolts in the order shown in the illustration.
For bolt A - Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
For except bolt A - Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
NOTE: Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.
Tighten the 10 bolts in the order shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)
CAMSHAFT HOUSING SUB-ASSEMBLY LH
NOTICE:
- Remove any oil from the contact surface.
- Install the camshaft housing within 3 minutes and tighten the bolts within 15 minutes after applying seal packing.
- Do not start the engine for at least 2 hours after the installation.
Install the camshaft housing, and install the 18 bolts in the order shown in the illustration.
For bolt A - Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
For except bolt A - Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
NOTE: Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.
Tighten the 10 bolts in the order shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)