Canada - ABS - Rear Speed Sensor Wire DTC C1332/C1333

Bulletin
TSB3085

Issue Date
November 13, 2008

Market
Canada

Title
REAR SPEED SENSOR WIRE REPLACEMENT FOR DTCS C1332 AND/ OR C1333

Component
Brakes

Models
'07-'08 Tundra

INTRODUCTION:

Some 2007-2008 Model Year Tundra vehicles may experience an ABS/VSC warning light with DTCs C1332 and/or C1333. Please use the following procedure to address customer concerns.






APPLICABILITY:






PARTS INFORMATION:






WARRANTY INFORMATION:






REQUIRED SSTS:

PRODUCTION CHANGE INFORMATION:







This TSB applies to vehicles produced BEFORE the Production Change Effective VINs shown.

REPAIR PROCEDURE

1. Using Techstream, check for stored DTCs.
2. Verify DTC(s) C1332 and/or C1333 are present.







3. Remove the connector (RB1) where the two speed sensor wires come together, located above the rear differential.
4. Inspect the speed sensor wire junction for corrosion/damage. If there is corrosion/damage to the wire, proceed to step 6.
5. If the wires are not corroded or damaged please refer to the Repair Manual within E-TAS / TIS library for further information on diagnostic steps:
- Division: Toyota
- Model: Tundra
- Year: 2007 or 2008
- Service Category: Brake
- Section: Brake Control/Dynamic Control System
- Keyword: Vehicle Stability Control System: C0210/33: Right Rear Wheel Speed Sensor Signal

6. Disconnect the speed sensor wires from each speed sensor and any clips that retain the wire to the differential.
7. Install the new speed sensor wire.
8. Connect the Techstream or the scan tool to the vehicle and select the data list from ABS/VSC/TRAC menu.
9. Test drive the vehicle to confirm that all speed sensor values are correct and coincide with the actual speed of the vehicle.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.