Canada - Brakes - ABS/MIL/4WD Lamps ON/DTC U0129/P0500

Bulletin
2825R

Issue Date
August 28, 2007

Market
Canada

Title:
ABS, BRAKE, OR 4WD M.I.L. ILLUMINATED

Component
BRAKES

Models
'07-'08 Tundra

TSB REVISION NOTICE:
- November 25, 2008 : Applicability has been updated to include 2008 year.
- Production Change Information has been updated.
Previous versions of this TSB should be discarded.

INTRODUCTION:
The following information is provided to supplement the Repair Manual. In 2007-2008 model year Tundra vehicles, if the ABS, Brake, 4WD, and/or "Check Engine" light is "ON" due to DTCs U0129 and P0500, the brake actuator assembly should be replaced. Use the following repair procedure to address customer concerns.

APPLICABLE VEHICLES:
- 2007-2008 model year Tundra vehicles produced BEFORE the Production Change Effective VINs shown in this TSB.







PARTS INFORMATION:







WARRANTY INFORMATION:







PRODUCTION CHANGE INFORMATION:







REQUIRED SSTS:

NOTE:
- Please contact your zone Area Parts & Service Managers to order additional Techstream units.
- The Lexus Diagnostic Tester (TDT) and CAN Interface Module may also be used to perform the service procedures listed in this bulletin.

REPAIR PROCEDURE:
1. Remove the brake actuator.

Refer to the Repair Manual within E-TAS / TIS library:
- Division: Toyota
- Model: Tundra
- Year: 2007/2008
- Service Category: Brake
- Section: Brake Control/Dynamic Control System
- Keyword: Brake Control: Brake Actuator: Removal

2. Install a NEW brake actuator.

Refer to the Repair Manual within E-TAS / TIS library:
- Division: Toyota
- Model: Tundra
- Year: 2007/2008
- Service Category: Brake
- Section: Brake Control/Dynamic Control System
- Keyword: Brake Control: Brake Actuator: Installation

NOTE:
Techstream software version 2.11.004 or later is required to perform air bleeding of the Brake Control System.

3. Road test the vehicle to confirm concerns is NO longer present.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.