Ignition Switch Circuit

THEFT DETERRENT: THEFT DETERRENT SYSTEM: Ignition Switch Circuit

Ignition Switch Circuit

DESCRIPTION

When the ignition switch is turned to the ON position, battery positive voltage is applied to terminal IG of the ECU. When battery positive voltage is applied to terminal IG of the ECU while the theft deterrent system is operating, the warning stops.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSES (ECU-IG)
(a) Remove the ECU-IG fuse from the instrument panel J/B.
(b) Measure the resistance.
Standard resistance:
Below 1 Ohms

NG -- REPLACE FUSES
OK -- Continue to next step.

2. INSPECT IGNITION SWITCH ASSEMBLY
(a) Disconnect the I18 switch connector.




(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:





NG -- REPLACE IGNITION SWITCH ASSEMBLY
OK -- Continue to next step.

3. CHECK HARNESS OR CONNECTOR (POWER SOURCE)




(a) Disconnect the T5 ECU connector.
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE THEFT WARNING ECU ASSEMBLY