Body - Back Door Power Window Initialization
T-SB-0213-08August 11, 2008
Initialization of Back Door Power Window During PDS
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
This bulletin outlines the initialization procedure for the back door power window on the 4Runner.
To minimize the battery discharge during transportation and storage the Short Pin has been removed at the assembly plant resulting in the following feature being inoperative:
^ One-touch open and close with jam protection.
Use the following initialization procedure after installing the Short Pin during Pre-Delivery Service (PDS) and whenever the battery has been disconnected.
NOTE
Any time the battery terminal has been disconnected, the back door power window MUST be re-initialized.
Warranty Information
Initializing Procedure
NOTE
Make sure the Short Pin is installed in its original location. (Refer to TSB No. T-SB-0212-08, "Short Pin Installation During PDS.")
1. Turn ignition switch to the "IG-ON" position.
2. Push the back door power window switch "DOWN" to open the window.
3. Push and hold the back door power window switch "UP" until the window closes. Continue holding it for approximately 1 second.
4. Check for proper operation of the "one-touch open/close" functions by pushing the switch briefly "DOWN" and then "UP".
NOTE
Jam protection function becomes effective through the above initialization procedure.