Disassembly

ENGINE HOOD / DOOR: BACK DOOR: DISASSEMBLY

DISASSEMBLY

HINT: A bolt without a torque specification is shown in the standard bolt chart Removal.

1. REMOVE BACK DOOR TRIM BOARD





(a) Remove the assist strap hole cover.
(b) Remove the screw and assist strap.
(c) Using a screwdriver, remove the back door trim cover.

HINT:
Tape the screwdriver tip before use.
In order to prevent the back door from being damaged, cover the parts indicated by arrow marks in the illustration with tape.

(d) Using a clip remover, remove the 10 clips and trim board.
(e) Remove the inner weatherstrip.
2. REMOVE BACK DOOR SERVICE HOLE COVER LH





(a) Remove the back door service hole cover LH.

NOTE: Remove the remaining tape on the back door side.

3. REMOVE BACK DOOR GLASS
(a) Remove the 5 screws and service hole cover.

HINT:
- Do not disconnect the multiplex network door ECU connector.
- Fix the multiplex network door ECU with tape.
- If the door lock protector are damaged, exchange it for new door lock protector.





(b) Open the door glass until the bolts appear in the service hole.
(c) Remove the door glass run.

HINT: Since removing the glass run will make the glass loose, insert shop rug between the door glass and body panel.

(d) Disconnect the window defogger connector.





(e) Remove the 4 bolts and door glass.





(f) Remove the door glass as shown in the illustration.
(g) Disconnect the rear window connector.
(h) Remove the multiplex network door ECU.
4. REMOVE BACK DOOR GLASS WEATHERSTRIP ASSEMBLY OUTER Removal
5. REMOVE WITH MOTOR BACK DOOR LOCK ASSEMBLY
(a) Disconnect the back door lock connector.





(b) Remove the 2 back window regulator control wires.





(c) Disengage the 2 claws and remove the lock protector as shown in the illustration.
(d) Remove the 4 bolts and back door lock.

HINT: Remove the door lock through the service hole.

6. REMOVE BACK DOOR POWER WINDOW REGULATOR SUB-ASSEMBLY





(a) Remove the 2 cushion rubbers.
(b) Disconnect the window regulator connector.
(c) Remove the 6 bolts, nut and window regulator.

HINT: Remove the power window regulator through the service hole.

7. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH REAR





(a) Remove the 2 nuts and window regulator motor.
(b) Remove the 2 screws and cover plate.
(c) Using needle nose pliers, remove the drum and wire guide from the motor.

NOTE: Do not use a screwdriver, etc. when removing them.

8. REMOVE REAR WIPER MOTOR ASSEMBLY





(a) Remove the liner wiper step LH as shown in the illustration.
(b) Remove the rear wiper motor assembly Removal.
9. REMOVE BACK DOOR LOCK CYLINDER
(a) Disconnect the connector.
(b) Remove the tailgate control switch.
(c) Remove the 2 nuts and lock cylinder.

HINT: Remove the back door lock cylinder assembly through the service hole.

10. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
11. REMOVE TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System) Removal
12. REMOVE BACK DOOR STOPPER LOWER
(a) Remove the bolt and stopper lower.
13. REMOVE BACK DOOR LOWER STOPPER CUSHION
(a) Remove the 2 bolts and stopper cushion.
14. REMOVE REAR SPOILER SUB-ASSEMBLY (w/ Rear Spoiler) Removal
15. REMOVE CENTER STOP LIGHT ASSEMBLY (w/ Rear Spoiler) Removal
16. REMOVE CENTER STOP LIGHT ASSEMBLY (w/o Rear Spoiler) Removal