All Doors Lock/Unlock Functions Do Not Operate Via Master Switch, Driver Side Door Key Cylinder

DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side Door Key Cylinder

All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side Door Key Cylinder

DESCRIPTION

The body ECU receives a switch signal from the master switch and the driver side door key cylinder, and then drives the door lock motor.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM
(a) Select the active test, and then check that the power door lock operates.

HINT: During the active test, the Techstream sends signal to the body ECU to drive all the power door lock motor. If the all power door lock operates, the power door lock motor itself and the wire harness between the power door lock motor and body ECU are considered normal.

Body

NG -- REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK -- Continue to next step.

2. CHECK MASTER SWITCH OR KEY CYLINDER
(a) Check master switch or key cylinder operation.
(1) When manual door lock/unlock operation via the master switch can not be performed, proceed to A.
(2) When manual door lock/unlock operation via the door lock control switch (passenger side) can not be performed, proceed to B.
(3) When manual door lock/unlock operation interlocked with the driver side door lock key cylinder can not be performed, proceed to C.
C -- INSPECT FRONT DOOR W/MOTOR LOCK ASSEMBLY LH
B -- INSPECT DOOR CONTROL SWITCH ASSEMBLY
A -- Continue to next step.

3. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

(a) Remove the master switch.
(b) Inspect the door lock control switch continuity.
Standard resistance:

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR

NG -- REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
4. INSPECT DOOR CONTROL SWITCH ASSEMBLY

(a) Passenger side switch:
Inspect the door lock control switch continuity.
Standard resistance:

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR

NG -- REPLACE DOOR CONTROL SWITCH ASSEMBLY
5. INSPECT FRONT DOOR W/MOTOR LOCK ASSEMBLY LH

(a) Apply battery voltage and inspect operation of the door lock motor.
Standard:

(b) Inspect the door lock and unlock switch continuity.
Standard resistance:

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR

NG -- REPLACE FRONT DOOR W/MOTOR LOCK ASSEMBLY LH