Removal

BRAKE: REAR BRAKE: REMOVAL

REMOVAL

HINT: Use the same procedure for the RH side and LH side.

1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID

NOTE: Wash the brake fluid off immediately if it adheres to any painted surfaces.

3. DISCONNECT REAR FLEXIBLE HOSE LH





(a) Remove the union bolt and gasket from the disc brake cylinder, and then disconnect the flexible hose from the rear disc brake cylinder.

HINT: Use a container to catch brake fluid as it drains out.

4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH





(a) Remove the 2 cylinder slide pins from the rear disc brake cylinder.
(b) Remove the rear disc brake cylinder from the rear disc brake cylinder mounting.
5. REMOVE REAR DISC BRAKE PAD
(a) Remove the 2 brake pads together with the anti-squeal shims from rear disc brake cylinder mounting.
6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM
(a) Remove the 2 anti-squeal shims from the disc brake pads.
7. REMOVE REAR DISC BRAKE PAD WEAR INDICATOR PLATE
(a) Remove the pad wear indicator plate from the inner disc brake pad.
8. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
(a) Remove the 4 pad support plates from the rear disc brake cylinder mounting.
9. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH





(a) Remove the 2 bolts, 2 plate washers and rear disc brake cylinder mounting.
10. REMOVE REAR DISC BRAKE BUSH DUST BOOT
(a) Remove the disc brake bush dust boot from the rear disc brake cylinder mounting.
11. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH
(a) Remove the disc brake cylinder slide bush from the rear disc brake cylinder mounting.
12. REMOVE REAR DISC BRAKE CYLINDER HOLE PLUG
(a) Remove the rear disc brake cylinder hole plug from the rear disc brake cylinder mounting.
13. REMOVE REAR DISC
(a) Place matchmarks on the rear disc and axle hub.
(b) Remove the rear disc.