Installation

1GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT





(a) While turning the belt tensioner counterclockwise, align with its holes, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.
(b) Install the V-ribbed belt.
(c) While turning the belt tensioner counterclockwise, remove the bar.





(d) If it is hard to install the V-ribbed belt, perform the following procedure.
(1) Put the V-ribbed belt on all parts except the P/S pump, as shown in the illustration.
(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.
2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
(a) Install the No. 1 engine under cover with the 4 bolts.
Torque: 29 Nm (296 kgf-cm, 21 ft-lbf)