Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SEAT POSITION SENSOR
(a) Check that the ignition switch is off.
(b) Check that the negative battery (-) terminal is disconnected.

CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Install the seat position sensor with a new bolt.
Part Number:
Bolt
90119-06871
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(d) Check that there is no looseness in the installation parts of the seat position sensor.
(e) Connect the connector to the seat position sensor.
2. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat) Installation
3. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat) Installation
4. INSTALL SEAT TRACK BRACKET COVER INNER LH (for Manual Seat)
5. INSTALL SEAT TRACK BRACKET COVER INNER LH (for Power Seat)
6. INSTALL SEAT TRACK OUTER COVER LH (for Manual Seat)
7. INSTALL SEAT TRACK OUTER COVER LH (for Power Seat)
8. INSTALL SEAT TRACK BRACKET COVER INNER FRONT LH (for Manual Seat)
9. INSTALL SEAT TRACK BRACKET COVER INNER FRONT LH (for Power Seat)
10. INSTALL SEAT TRACK BRACKET COVER OUTER FRONT LH (for Manual Seat)
11. INSTALL SEAT TRACK BRACKET COVER OUTER FRONT LH (for Power Seat)
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat)
14. INSPECT POWER SEAT OPERATION (for Power Seat)
15. INSPECT SEAT HEATER OPERATION (w/ Seat Heater System)
16. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.