Removal
SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: REMOVAL
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE TONNEAU COVER RETRACTOR SUB-ASSEMBLY
4. REMOVE DECK BOARD ASSEMBLY Removal
5. REMOVE REAR FLOOR MAT SUPPORT PLATE REAR Removal
6. REMOVE DECK FLOOR BOX LH
7. REMOVE REAR DOOR SCUFF PLATE LH
8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
9. REMOVE LAP BELT OUTER ANCHOR COVER REAR NO. 1 SEAT
10. REMOVE DECK TRIM SIDE BOARD UPR LH
11. REMOVE DECK SIDE TRIM COVER LH
12. REMOVE REAR AIRBAG SENSOR LH
(a) Disconnect the connector from the rear airbag sensor LH.
(b) Remove the 2 nuts and the rear airbag sensor LH.