Camshaft Bearing
CAMSHAFTSInstall the camshaft of the RH bank.
Install the 16 bearing cap bolts. Using several steps, tighten the bolts uniformly in the sequence as shown in the illustration.
For 10 mm (0.39 in.) head - Torque 9.0 Nm (92 kgf-cm, 80 in-lbf)
For 12 mm (0.47 in.) head - Torque 24 Nm (245 kgf-cm, 18 ft-lbf)
Install the camshafts of the LH bank
Install the 16 bearing cap bolts. Using several steps, tighten the bolts uniformly in the sequence as shown in the illustration.
For 10 mm (0.39 in.) head - Torque 9.0 Nm (92 kgf-cm, 80 in-lbf)
For 12 mm (0.47 in.) head - Torque 24 Nm (245 kgf-cm, 18 ft-lbf)
CAMSHAFTS (for Bank 2)
Using several steps, install and tighten the 16 bearing cap bolts uniformly in the sequence as shown in the illustration.
For 10 mm (0.39 in.) head - Torque 9.0 Nm (92 kgf-cm, 80 in-lbf)
For 12 mm (0.47 in.) head - Torque 24 Nm (245 kgf-cm, 18 ft-lbf)
NO. 2 CAMSHAFT BEARING
Using several steps, install and tighten the 16 bearing cap bolts uniformly in the sequence as shown in the illustration.
For 10 mm (0.39 in.) head - Torque 9.0 Nm (92 kgf-cm, 80 in-lbf)
For 12 mm (0.47 in.) head - Torque 24 Nm (245 kgf-cm, 18 ft-lbf)
CAMSHAFTS (for Bank 1)
Using several steps, install and tighten the 16 bearing cap bolts uniformly in the sequence as shown in the illustration.
For 10 mm (0.39 in.) head - Torque 9.0 Nm (92 kgf-cm, 80 in-lbf)
For 12 mm (0.47 in.) head - Torque 24 Nm (245 kgf-cm, 18 ft-lbf)