Installation

SUSPENSION: REAR STABILIZER BAR: INSTALLATION

INSTALLATION

1. INSTALL STABILIZER BAR REAR





(a) Install the 2 stabilizer bushes to the stabilizer bar.

HINT: Install the stabilizer bush to the inner side of the stabilizer bush stopper on the stabilizer bar.





(b) Install the stabilizer bar and the 2 stabilizer brackets with the 4 bolts.
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
2. INSTALL REAR STABILIZER LINK ASSEMBLY





(a) Install the stabilizer link with the nut (LH side).
Torque: 70 Nm (714 kgf-cm, 52 ft-lbf)

HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.

(b) Install the 2 retainers and the cushion to the stabilizer link.





(c) Hold the stabilizer bar link with a wrench, and install the nut, retainer, cushion and link.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
3. REMOVE REAR STABILIZER LINK ASSEMBLY

HINT: Install the RH side by following the same procedures with the LH side.

4. INSTALL REAR WHEEL
Torque: 112 Nm (1,137 kgf-cm, 83 ft-lbf)