Installation

SUSPENSION CONTROL: HEIGHT CONTROL COMPRESSOR: INSTALLATION

INSTALLATION

1. INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY
(a) Install the 3 bushings to the height control compressor assembly.
(b) Install the bolt, the dryer and the new O-ring.
Torque: 6.4 Nm (65 kgf-cm, 57 in-lbf)
(c) Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.
Torque: 29 Nm (300 kgf-cm, 21 ft-lbf)
(d) Install the height control compressor assembly to the bracket with the 3 bolts.
Torque: 5.9 Nm (60 kgf-cm, 52 in-lbf)
(e) Install the 3 clamps.
(f) Connect the connector.
(g) Connect the No. 1 hose with a new clip.
2. CONNECT HEIGHT CONTROL TUBE NO. 2
(a) Coat 2 new O-rings with MP grease.
(b) Push the height control tube No. 2 in straight to connect it until the clip makes "click" sound.

NOTE: Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.

(c) Install the holder.
3. INSTALL HEIGHT CONTROL FILTER
(a) Install the height control filter with the new 2 bolts.
Torque: 6.4 Nm (65 kgf-cm, 57 in-lbf)
(b) Connect 2 new clips and 2 hoses.
4. INSTALL HEIGHT CONTROL COMPRESSOR COVER
(a) Install the height control compressor cover with 3 new clips.
5. CHECK AIR LEAK
6. INSTALL SPARE DISC WHEEL
7. INSTALL FUEL TANK FILLER PIPE PROTECTOR
(a) Install the fuel tank filler pipe protector with the 4 clips.
8. INSTALL REAR BUMPER Installation
9. INSTALL QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR LH
10. INSTALL REAR DISC WHEEL
Torque: 112 Nm (1,140 kgf-cm, 83 ft-lbf)