Disassembly

LIGHTING: HEADLIGHT ASSEMBLY: DISASSEMBLY

DISASSEMBLY

1. REMOVE HEADLIGHT NO. 1 BULB





(a) Remove the headlight No. 1 bulb as shown in the illustration.
2. REMOVE HEADLIGHT NO. 2 BULB





(a) Remove the headlight No. 2 bulb as shown in the illustration.
3. REMOVE FRONT TURN SIGNAL LIGHT BULB





(a) Remove the front turn signal light bulb as shown in the illustration.
4. REMOVE CLEARANCE LIGHT BULB





(a) Remove the clearance light bulb as shown in the illustration.
- Since the low-beam light and the high-beam light are a unit, if the aim on one is correct, the other should also be correct. However, check both beams just to make sure.
- Alignment distance is 7.62 m (25 ft):
The cutoff line is 101 mm (3.97 in.) above and below the H line as well as left and right of the V line with low-beam (SAE J599).
- Alignment distance is 3 m (9.84 ft):
The cutoff line is 40 mm (1.57 in.) above and below the H line as well as left and right of the V line with low-beam (SAE J599).
- Alignment distance is 7.62 m (25 ft):
The cutoff line is 101 mm (3.97 in.) above and below the H line as well as left and right of the V line with high-beam (SAE J599).
- Alignment distance is 3 m (9.84 ft):
The cutoff line is 40 mm (1.57 in.) above and below the H line as well as left and right of the V line with high-beam (SAE J599).
- Alignment distance is 7.62 m (25 ft):
The cutoff line is 53 mm (2.08 in.) below the H line with low-beam.
- Alignment distance is 3 m (9.84 ft):
The cutoff line is 21 mm (0.82 in.) below the H line with low-beam.