Maintenance Indicator Reset

After changing the engine oil, the oil change system should be reset. Perform the following procedures:

Step 1: Turn the engine switch to the ACC or LOCK position with the odometer reading shown.
Step 2: Turn the engine switch to the ON position while holding down the trip meter reset button.
Step 3: Hold down the button until the light goes off. Before the light goes off, it illuminates for 3 seconds, flashes for 2 seconds and illuminates for 1 second.

If the system fails to reset, the light will remain flashing.


Navigation Maintenance Item Setting (If equipped)

When the navigation system is turned on, the "Information" screen displays when it is time to replace a part or certain components.

1. Push the "INFO" button.

2. Touch "Maintenance"

3. Touch the desired button.

"Delete All": To cancel all conditions which have been input.

"Reset All" : To reset the item which has satisfied a condition.

If "ON" is selected, the system gives maintenance information with the "Information" screen when the system is turned on.

If "OFF" is selected, the "Information" screen is disabled.

When the vehicle needs to be serviced, the touch screen button color will change to orange.

4. Input the conditions.

Notice of "Date": The next maintenance date can be input.

Notice of "Distance": The driving distance until the next maintenance check can be input.

"Delete": To cancel the date and distance conditions.

"Reset": To reset the date and distance conditions.

5. Touch "OK" The screen returns to the "Maintenance" screen.


Note:

- For scheduled maintenance information, please refer to the Scheduled maintenance guide or Owners manual supplement.

- Depending on your driving or the road conditions, the system may have a time-lag between the data which has been input and the actual date and driving distance.