Camshaft Bearing
CAMSHAFTSInstall the camshafts of the RH bank
Do not apply engine oil under the heads of the bearing cap bolts (A), (B) and (C).
Each bolt length is as follows:
94 mm (3.70 in.) for A with seal washer
G72 mm (2.83 in.) for B with seal washer
25 mm (0.98 in.) for C
55 mm (2.17 in.) for D
40 mm (1.57 in.) for E
Uniformly tighten the 22 bearing cap bolts in several steps, in the order shown in the illustration.
For bolt C - Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
For others - Torque 16 Nm (163 kgf-cm, 12 ft-lbf)
Install the camshafts of the LH bank
Do not apply engine oil under the heads of the bearing cap bolts (A), (B) and (C).
Each bolt length is as follows:
94 mm (3.70 in.) for A with seal washer
72 mm (2.83 in.) for B with seal washer
25 mm (0.98 in.) for C
55 mm (2.17 in.) for D
0 mm (1.57 in.) for E
Uniformly tighten the 22 bearing cap bolts in several steps, in the order shown in the illustration.
For bolt C - Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
For others - Torque 16 Nm (163 kgf-cm, 12 ft-lbf)
NO. 3 AND NO. 4 CAMSHAFT SUB-ASSEMBLY
Do not apply engine oil under the heads of bearing cap bolts.
Each bolt length is as follows:
94 mm (3.70 in.) for A with seal washer
72 mm (2.83 in.) for B with seal washer
Do not apply engine oil under the heads of bearing cap bolts C.
Each bolt length is as follows:
25 mm (0.98 in.) for C
55 mm (2.17 in.) for D
40 mm (1.57 in.) for E
Uniformly tighten the 22 bearing cap bolts in several steps, in the order shown in the illustration.
For bolt C - Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
For others - Torque 16 Nm (163 kgf-cm, 12 ft-lbf)