Removal

A750F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION ASSEMBLY (for 2UZ-FE): REMOVAL

REMOVAL

1. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY
2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
3. DISCONNECT OXYGEN SENSOR

HINT: Removal

4. REMOVE EXHAUST PIPE

HINT: Removal

5. REMOVE FRONT PROPELLER SHAFT ASSEMBLY Removal
6. REMOVE PROPELLER SHAFT ASSEMBLY Removal
7. DRAIN AUTOMATIC TRANSMISSION FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and drain plug.
Torque: 28 Nm (285 kgf-cm, 21 ft-lbf)
8. REMOVE FRONT SUSPENSION MEMBER BRACKET





(a) Remove the 4 bolts and front suspension member bracket.
9. REMOVE FRONT SUSPENSION MEMBER BRACKET LH
(a) Remove the 4 bolts and front suspension member bracket LH.
10. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
(a) Remove the ATF level gauge.
(b) Remove the bolt and oil filler tube.
(c) Remove the O-ring from the oil filler tube.
11. DISCONNECT NO.1 OIL COOLER OUTLET TUBE





(a) Remove the 2 bolts and 2 clamps.





(b) Using a union nut wrench, disconnect the No. 1 oil cooler outlet tube.
12. REMOVE NO.1 OIL COOLER INLET TUBE
(a) Using a union nut wrench, disconnect the No. 1 oil cooler inlet tube.
13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Remove the nut and disconnect the transmission control cable.
(b) Remove the 2 bolts and disconnect the transmission control cable.
14. REMOVE NO.1 TRANSMISSION CONTROL CABLE BRACKET
(a) Remove the 2 bolts and transmission control cable bracket
15. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY





(a) Support the automatic transmission assembly with a transmission jack.
16. REMOVE NO.3 FRAME CROSSMEMBER SUB-ASSEMBLY





(a) Remove the 4 bolts on the No. 3 frame crossmember sub-assembly.
(b) Remove the 4 nuts, 4 bolts and No. 3 frame crossmember sub-assembly.
17. DISCONNECT CONNECTOR





(a) Tilt down the transmission.

NOTE: Take care so that the cooling fan does not come in contact with the fan shroud.

(b) Disconnect the park/neutral position switch connector.
(c) Disconnect the transmission wire connector.
(d) Disconnect the 2 speed sensor connectors.
18. DISCONNECT WIRE HARNESS
19. REMOVE FLYWHEEL HOUSING UNDER COVER





(a) Remove the 2 bolts and flywheel housing under cover.
20. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY





(a) Turn the crankshaft to gain access to each bolt.
(b) Hold the crankshaft pulley nut with a wrench and remove the 6 bolts.





(c) Remove the 10 bolts.
(d) Separate and remove the automatic transmission.
21. REMOVE TRANSFER ASSEMBLY Removal
22. REMOVE NO.1 REAR ENGINE MOUNTING INSULATOR





(a) Remove the 4 bolts and No.1 rear engine mounting insulator from the automatic transmission.
23. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY
24. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

HINT: Testing and Inspection

SST: 09350-32014