Removal

ENGINE HOOD / DOOR: BACK WINDOW SUPPORT: REMOVAL

REMOVAL

1. PRECAUTION
NOTE: If a back window stay assembly is removed and installed, the location of the axis of the rear wiper motor assembly will change, causing the wiping angle to change. Be sure to remove and install the rear wiper motor assembly using the centering jig.

2. REMOVE BACK WINDOW STAY ASSEMBLY
NOTICE:
- Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinders while servicing.
- Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the piston rod and result in gas leaks.
- Do not apply any horizontal load to the window stay in the in order to prevent the piston rod from deforming.





(a) Using a screwdriver with the tip taped, remove the stop ring along the groove.
(b) Release the ball joint and remove the back window stay assembly.
NOTE: Remove the back door stay assembly while supporting the back door by hand.

3. REMOVE BACK WINDOW STAY BOLT





(a) Remove the back window stay bolt.