Cylinder Head Assembly: Specifications

CYLINDER HEAD SUB-ASSEMBLY RH

Step 1

Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps and in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)

Step 2
Mark the cylinder head bolt head with paint as shown in the illustration.
Tighten the cylinder head bolts another 90°.

Step 3
Tighten the cylinder head bolts an additional 90°.
Check that the painted mark is now facing rearward.

CYLINDER HEAD SUB-ASSEMBLY LH

Step 1

Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)

Tighten the 2 bolts in the order shown in the illustration.
Torque 30 Nm (306 kgf-cm, 22 ft-lbf)

HEAD SET BOLT

SURFACE VARIATION

INTAKE MANIFOLD

Install the intake manifold with the 6 bolts and 4 nuts in the order shown in the illustration.
Torque 21 Nm (214 kgf-cm, 15 ft-lbf)

CAMSHAFT BEARING CAP (for Bank 1)

Temporarily tighten the 8 bearing cap bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

CAMSHAFT BEARING CAP (for Bank 2)

Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 1)

Torque 100 Nm (1020 kgf-cm, 74 ft-lbf)

CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 2)

Torque 100 Nm (1020 kgf-cm, 74 ft-lbf)

EXHAUST MANIFOLD SUB-ASSEMBLY RH

Install the exhaust manifold sub-assembly RH by tightening the 6 nuts in the order shown in the illustration.
Torque 21 Nm (214 kgf-cm, 15 ft-lbf)

EXHAUST MANIFOLD SUB-ASSEMBLY LH

Install the exhaust manifold sub-assembly LH by tightening the 6 nuts in the order shown in the illustration.
Torque 21 Nm (214 kgf-cm, 15 ft-lbf)