Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION

INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY





(a) Connect the connector.





(b) Install the tire pressure warning receiver assembly with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for INSTALLATION of the roof headlining Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: Test Mode Procedure.