Downhill Assist Control Switch

BRAKE CONTROL: DOWNHILL ASSIST CONTROL SWITCH (for 4WD): INSPECTION

INSPECTION

1. INSPECT DOWNHILL ASSIST CONTROL SWITCH





(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the result is not as specified, replace the downhill assist control switch.
(b) Check the illumination operation.
(1) Connect a battery positive (+) lead to terminal 3 and negative (-) lead to terminal 2. Then check that the bulb in the switch illuminates.
OK:
Bulb illuminates.
If the result is not as specified, replace the downhill assist control switch.