Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SEAT POSITION SENSOR





(a) Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.051 in.) feeler gauge, temporarily install the seat position sensor.

NOTICE :
- If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
- When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
HINT: Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 2.0 mm (0.079 in.).





(c) Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(d) Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 2.0 mm (0.079 in.).
(e) Connect the connector.
(f) Check that there are no loose parts after installing the seat position sensor.
2. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat) Installation
3. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (for Manual Seat) Installation
4. INSTALL REAR SEAT TRACK COVER LH (for Manual Seat) Installation
5. INSTALL FRONT INNER SEAT TRACK COVER LH (for Manual Seat) Installation
6. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Manual Seat) Installation
7. INSTALL FRONT SEAT HEADREST ASSEMBLY LH (for Manual Seat) Installation
8. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat) Installation
9. INSTALL REAR INNER SEAT TRACK COVER LH (for Power Seat) Installation
10. INSTALL REAR OUTER SEAT TRACK COVER LH (for Power Seat) Installation
11. INSTALL FRONT INNER SEAT TRACK COVER LH (for Power Seat) Installation
12. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Power Seat) Installation
13. INSTALL FRONT SEAT HEADREST ASSEMBLY LH (for Power Seat) Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Manual Seat)
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSPECT FRONT SEAT ASSEMBLY (for Power Seat) Installation
16. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.