Installation

U151F AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY





(a) Install the park/neutral position switch to the manual valve shaft.
(b) Temporarily install the 2 bolts.





(c) Place a new lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 in-lbf)
(d) Temporarily install the control shaft lever.





(e) Turn the lever counterclockwise until it stops and then turn it clockwise 2 notches.
(f) Remove the control shaft lever.





(g) Align the groove with the neutral basic line.
(h) Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)





(i) Using a screwdriver, bend the tabs of the lock plate.





(j) Install the control shaft lever washer and nut.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)





(k) Connect the park/neutral position switch connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Connect the control cable to the control shaft lever with the nut.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)





(b) Install the control cable to the bracket with a new clip.
3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY Adjustments
4. ADJUST SHIFT LEVER POSITION Adjustments
5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION On-Vehicle Inspection
6. INSPECT SHIFT LEVER POSITION On-Vehicle Inspection
7. INSTALL AIR CLEANER BRACKET Installation
8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation
9. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
11. INSTALL NO. 1 AIR CLEANER INLET Installation
12. INSTALL NO. 2 AIR CLEANER INLET Installation
13. INSTALL COOL AIR INTAKE DUCT SEAL Installation
14. INSTALL BATTERY Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.