System Specifications

NO. 2 CHAIN TENSIONER ASSEMBLY





Install the chain tensioner with the 2 bolts.

Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

While raising up the No. 2 chain tensioner, insert a pin of dia1.0 mm (0.0394 in.) into the hole to fix it in place

NO. 1 CHAIN TENSIONER ASSEMBLY (for RH Side)





Install the chain tensioner with the 2 bolts.

Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

NO. 3 CHAIN TENSIONER ASSEMBLY





Install the chain tensioner with the 2 bolts.

Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

NO. 1 CHAIN TENSIONER ASSEMBLY (for LH Side)





Install a new gasket and the chain tensioner with the 2 bolts.

Torque 10 Nm (102 kgf-cm, 7 ft-lbf)

TIMING CHAIN OR BELT COVER SUB-ASSEMBLY





Temporarily install the timing chain cover with the 28 bolts and nut.

Standard Bolt:









Tighten the 3 bolts in several steps in the sequence shown in the illustration.

Torque 47 Nm (479 kgf-cm, 35 ft-lbf)





Temporarily install the fluid coupling bracket with the 4 bolts.

Standard Bolt:









Temporarily install the belt tensioner with the standard bolt and 6 mm hexagon wrench bolt.





Tighten the 8 bolts labeled 4 to 11 in several steps in the sequence shown in the illustration.

Torque 47 Nm (479 kgf-cm, 35 ft-lbf)

Tighten the 23 bolts and nut labeled 12 to 35 in several steps in the sequence shown in the illustration.





Torque 23 Nm (235 kgf-cm, 17 ft-lbf)

After the installation, if the seal packing has seeped out at the areas labeled A shown in the illustration, wipe it off.





CRANKSHAFT PULLEY

Torque 300 Nm (3059 kgf-cm, 221 ft-lbf)