Operation CHARM: Car repair manuals for everyone.

Vehicle Stability Control System (for Vacuum Brake Booster)








BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster):

DIAGNOSTIC TROUBLE CODE CHART
NOTICE: When removing any parts, turn the ignition switch off.
HINT:
- If no abnormality is found when inspecting parts, check the skid control ECU and check for poor contact at ground points.
- If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code.
- When 2 or more DTCs are detected, perform each circuit inspection until the problem is identified.
- All DTCs in the table below are detected in accordance with 1 trip detection logic.

DTC Chart of ABS

C0200/31 - C0278/11:





C0279/12 - C1246/46:





C1249/49 - C1442/44 / U0073/94 - U0124/95:





HINT: *1: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
2. Clear the DTC(s).

DTC Chart of VSC

43 / C1201/51 - C1443/34:





C1445/66 / U0100/65 - U0126/63:





Test Mode DTC of ABS

C1271/71 - C1281/81:





Test Mode DTC of VSC

C0371/71: