Pinout Values and Diagnostic Parameters

CAN COMMUNICATION SYSTEM: TERMINALS OF ECU

TERMINALS OF ECU
HINT: This section describes the standard CAN values for all CAN related components.

1. CHECK CAN JUNCTION CONNECTOR
(a) CAN junction connector.





Wiring Color





Wiring Color









(b) Terminals of connectors for CAN junction connector.










(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






2. CHECK DLC3





(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






3. CHECK SKID CONTROL ECU (for Hydraulic Booster Type)
(a) Disconnect the connector S1 from the skid control ECU.
(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:






4. CHECK SKID CONTROL ECU (for Vacuum Booster Type)
(a) Disconnect the connector S1 from the skid control ECU.
(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:






5. CHECK STEERING ANGLE SENSOR
(a) Disconnect the connector S9 from the steering angle sensor.





(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






6. CHECK YAW RATE AND DECELERATION SENSOR
(a) Disconnect the connector Y1 from the yaw rate and deceleration sensor.





(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






7. CHECK ECM
(a) Disconnect the connector E4, E7, and E8 or E12, E13, and E14 from the ECM.





(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for 2TR-FE






Standard Resistance:
for 1GR-FE