Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT CUSHION ASSEMBLY (w/ Occupant Classification ECU, Occupant Classification Sensor): INSTALLATION

INSTALLATION
NOTICE:
- Install new parts from prepared service kits.
- Never use SRS parts from another vehicle. When replacing the parts, replace them with new ones.
- Never reuse an occupant classification sensor involved in a collision when the airbag has deployed.
- If the occupant classification sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the occupant classification sensor, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- After installing, shake the occupant classification sensor to check that there is no looseness.
- Remove the front seat cushion cover pad and front seat cushion cover together, in order to avoid occupant classification sensor malfunctions.

1. INSTALL OCCUPANT CLASSIFICATION SENSOR
(a) Install the occupant classification sensor with the 2 clips.
(b) Engage the clamps to the seat cushion frame.
(c) Pass the tube of the occupant classification sensor through marked portion A and then fix it at marked portion B on the front seat cushion spring assembly with the wiring harness clamp, as shown in the illustration.
HINT: Cut the wiring harness clamp leaving 5 to 10 mm (0.20 to 0.39 in.) at the end.

(d) Connect the connector to the occupant classification sensor.





2. INSTALL FRONT SEAT CUSHION SPRING ASSEMBLY Reassembly
3. INSTALL FRONT SEAT OUTER TRACK ASSEMBLY LH Reassembly
4. INSTALL FRONT SEAT OUTER TRACK ASSEMBLY RH Reassembly
5. INSTALL FRONT SEAT TRACK LOWER REAR BRACKET LH Reassembly
6. INSTALL FRONT SEAT TRACK LOWER REAR BRACKET RH Reassembly
7. INSTALL FRONT SEAT TRACK LOWER FRONT BRACKET LH Reassembly
8. INSTALL FRONT SEAT TRACK LOWER FRONT BRACKET RH Reassembly
9. INSTALL OCCUPANT CLASSIFICATION ECU Installation
10. INSTALL FRONT SEATBACK ASSEMBLY Reassembly
11. INSTALL FRONT SEAT HINGE COVER LH Reassembly
12. INSTALL FRONT SEAT HINGE COVER RH Reassembly
13. INSTALL FRONT SEAT ASSEMBLY Installation
14. INSTALL FRONT SEAT HEADREST ASSEMBLY Installation
15. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH Installation
16. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH Installation
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
18. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK Initialization
19. INSPECT SRS WARNING LIGHT Diagnosis System