Installation

WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS (for Access Cab): INSTALLATION

INSTALLATION





1. CLEAN VEHICLE BODY
(a) Clean and shape the contact surface of the vehicle body.
(1) Using a knife, cut away any rough adhesive on the contact surface of the vehicle body to ensure the appropriate surface shape.
NOTICE: Be careful not to damage the vehicle body.
HINT: Leave as much adhesive on the vehicle body as possible.
(2) Clean the contact surface of the vehicle body with a shop rag saturated with cleaner.
HINT: Even if all the adhesive has been removed, clean the vehicle body.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
(a) Using a brush, apply Primer M to the exposed part of the vehicle body.
NOTICE:
- Allow the primer to dry for 3 minutes or more.
- Do not apply Primer M to the adhesive.
- Throw away any leftover Primer M.
- Do not apply too much Primer M.





(b) Using a brush or sponge, apply Primer G to the edge of the quarter window and contact surface.
Specification:





NOTE:
- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover Primer G.
- Do not apply too much Primer G.
HINT: If Primer G is applied to any areas other than that which is specified, wipe off the primer with a clean shop rag before it dries.





(c) Apply adhesive.
Adhesive:
Part No. 08850-00801 or equivalent
(1) Cut off the tip of the cartridge nozzle, as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the time indicated in the table bellow.

Usage time frame:





(2) Load the sealer gun with the cartridge.
(3) Apply adhesive to the quarter window as shown in the illustration.
Specification:






3. CHECK FOR LEAKAGE AND REPAIR
(a) Conduct a leak test after the adhesive has completely hardened.
(b) Seal any leakage with auto glass sealer.
4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY Reassembly
5. INSTALL LAP BELT OUTER ANCHOR COVER Reassembly
6. INSTALL REAR ACCESS PANEL WEATHERSTRIP Reassembly