Operation CHARM: Car repair manuals for everyone.

Display Signal Circuit Between Television Display Assembly and Navigation Receiver Assembly





NAVIGATION: NAVIGATION SYSTEM: Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly
- Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

DESCRIPTION

This circuit sends a DVD image signal from the television display assembly to the navigation receiver assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION DISPLAY ASSEMBLY)

(a) Disconnect navigation receiver assembly connector E6 and television display assembly connector Q13.





(b) Measure the resistance according to the value(s) in the table below.





Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. INSPECT TELEVISION DISPLAY ASSEMBLY

(a) Reconnect television display assembly connector Q13.





(b) Measure the waveform according to the table below.

OK:





HINT
The waveform pattern may differ from that shown in the illustration below due to differences in the oscilloscope setting. A normal television display assembly operating condition can be determined if any waveform is output.

(c) Oscilloscope waveform





(1) Terminal: Q13-11 (NTS1) - Body ground

Setting: 200 mV/DIV., 10 micro s/DIV.

Condition: DVD display is ON.

NG -- REPLACE TELEVISION DISPLAY ASSEMBLY Removal

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures