No Answer-Back

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System): No Answer-Back
- No Answer-Back

DESCRIPTION

In some cases, wireless door lock control functions are normal but the hazard warning lights and/or wireless door lock buzzer answer-back function(s) do not operate. In such cases, the main body ECU's hazard warning lights and wireless door lock buzzer signal outputs may be malfunctioning.

NOTICE:
Troubleshooting should be started after confirming that the customize status of the answer-back function has been switched ON.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (DOOR LOCK POSITION SWITCH)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to the ON position.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Data List.

(e) Read the Data List according to the display on the Techstream.

Main Body (Main Body ECU (Instrument Panel Junction Block))





OK:

On the Techstream screen, the display changes between ON and OFF as shown in the chart above.

Result:





E -- GO TO POWER DOOR LOCK CONTROL SYSTEM Only Rear Door Rh Lock / Unlock Functions Do Not Operate

D -- GO TO POWER DOOR LOCK CONTROL SYSTEM Only Rear Door Lh Lock / Unlock Functions Do Not Operate

C -- GO TO POWER DOOR LOCK CONTROL SYSTEM Only Passenger Door Lock / Unlock Functions Do Not Operate

B -- GO TO POWER DOOR LOCK CONTROL SYSTEM Only Driver Door Lock / Unlock Functions Do Not Operate
A -- Continue to next step.

2. CHECK WIRELESS DOOR LOCK CONTROL FUNCTION

(a) Check the wireless door lock control functions by operating the transmitter switch.

Result:





C -- GO TO PROBLEM SYMPTOMS TABLE Problem Symptoms Table

B -- PERFORM ACTIVE TEST USING TECHSTREAM (WIRELESS DOOR LOCK BUZZER)
A -- Continue to next step.

3. CHECK HAZARD WARNING LIGHT

(a) Check that the hazard warning lights flash continuously when the hazard warning signal switch is pressed.

OK:

Hazard warning lights flash continuously.

NG -- GO TO LIGHTING SYSTEM Symptom Related Diagnostic Procedures
OK -- Continue to next step.

4. PERFORM ACTIVE TEST USING TECHSTREAM (FLASHER RELAY)

(a) Select the Active Test, use Techstream to generate a control command, and then check that the hazard warning lights flash.

Main Body





OK:

Hazard warning lights are turned ON / OFF.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MAIN BODY ECU

5. PERFORM ACTIVE TEST USING TECHSTREAM (WIRELESS DOOR LOCK BUZZER)

(a) Select the Active Test, use Techstream to generate a control command, and then check that the wireless buzzer operate normally.

Main Body





OK:

Wireless buzzer turns ON/OFF.

NG -- INSPECT WIRELESS DOOR LOCK BUZZER

OK -- REPLACE MAIN BODY ECU

6. INSPECT WIRELESS DOOR LOCK BUZZER





(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NOTICE:
* The buzzer circuit is built into the main body ECU, not into the buzzer itself.
* When battery voltage is directly applied to the buzzer, the buzzer does not sound.

NG -- REPLACE WIRELESS DOOR LOCK BUZZER Removal
OK -- Continue to next step.

7. CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MAIN BODY ECU AND BODY GROUND)





(a) Disconnect the A13 wireless door lock buzzer connector.

(b) Disconnect the D10 main body ECU connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MAIN BODY ECU