Body - Roof Rack Leg Cover Installation Procedure

T-SB-0308-09

Rev1

September 1, 2009

Roof Rack Leg Cover Installation During PDS

Service Category
General

Section
Pre-Delivery Service

Market
USA





Applicability

TSB REVISION NOTICE

January 26, 2010 Rev1:

^ Step 1 has been updated.

Any previous printed versions of this service bulletin should be discarded.

Introduction

To prevent damage to the roof rack leg cover prior to installation of the crossbars the leg covers are not installed from the factory. Install the roof rack leg covers according to the following procedure during Pre-Delivery Service (PDS). Crossbars for DIO should be installed prior to the installation of the roof rack leg covers.





Warranty Information

Installation Procedure

For roof rack crossbar installation follow the installation instructions found on the Technical Information System (TIS).

NOTE

The roof rack leg covers are stored in the vehicle's cargo area.





1. Install the right and left rear roof rack leg covers in the following sequence (labeled in Figure 1).

A. Insert the tab at the front of the cover into the roof rack rail.

B. Place the cover on the leg and align the rear part of the cover. Do NOT press down.

C. Press the cover claws facing the inside of the vehicle into place.

NOTE

Do NOT press the claws facing the outside of the vehicle at the same time as pressing the claws facing the inside. The leg cover may be damaged.

D. Press the cover claws facing the outside of the vehicle into place.

2. Check that the roof rack leg cover is installed securely.