Installation

2GR-FE ENGINE CONTROL SYSTEM: AIR FUEL RATIO SENSOR: INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly RH.

SST : 09224-00010

Torque : 40 Nm (408 kgf-cm, 30 ft-lbf for use with SST)

Torque : 44 Nm (449 kgf-cm, 32 ft-lbf for use without SST)

HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
* Make sure that SST and the wrench are connected in a straight line.
2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH Installation

3. INSTALL MANIFOLD STAY Installation

4. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY Installation

5. INSTALL CENTER EXHAUST PIPE ASSEMBLY Installation

6. INSTALL TAIL EXHAUST PIPE ASSEMBLY Installation

7. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) Installation

8. FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) Installation

9. INSPECT FOR EXHAUST GAS LEAK Installation

10. INSPECT AND ADJUST TRANSFER OIL (for 4WD)

HINT

11. INSTALL FRONT FLOOR COVER LH Installation

12. INSTALL NO. 2 ENGINE UNDER COVER Installation

13. INSTALL NO. 1 ENGINE UNDER COVER Installation

14. INSTALL ENGINE UNDER COVER ASSEMBLY Installation

15. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly LH.