Removal

2GR-FE ENGINE CONTROL SYSTEM: AIR FUEL RATIO SENSOR: REMOVAL

1. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

(a) Disconnect the air fuel ratio sensor connector and remove the clamp.





(b) Using SST, remove the sensor from the exhaust manifold sub-assembly LH.





SST : 09224-00010

2. REMOVE ENGINE UNDER COVER ASSEMBLY Removal

3. REMOVE NO. 1 ENGINE UNDER COVER Removal

4. REMOVE NO. 2 ENGINE UNDER COVER Removal

5. REMOVE FRONT FLOOR COVER LH Removal

6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) Removal

7. REMOVE TAIL EXHAUST PIPE ASSEMBLY Removal

8. REMOVE CENTER EXHAUST PIPE ASSEMBLY Removal

9. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY Removal

10. REMOVE MANIFOLD STAY Removal

11. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal

12. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly RH.





SST : 09224-00010