Installation
2GR-FE ENGINE CONTROL SYSTEM: ECM: INSTALLATION
1. INSTALL NO. 2 ECM BRACKET
(a) Install the 2 screws and No. 2 ECM bracket.
2. INSTALL NO. 1 ECM BRACKET
(a) Install the 2 screws and No. 1 ECM bracket.
3. INSTALL ECM
(a) Install the 2 nuts, bolt and ECM.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Install the wire harness clamp.
(c) Connect the 5 ECM connectors.
(d) Install the harness connector.
4. INSTALL TIRE PRESSURE WARNING ECU Installation
5. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (w/ Smart Key System) Installation
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT
Use the same procedures for the RH side and the LH side Installation
9. INSTALL FRONT DOOR SCUFF PLATE RH
HINT
Use the same procedures for the RH side and the LH side Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization
11. RESISTER TRANSMITTER ID
NOTICE:
If the tire pressure warning ECU is replaced, resister the transmitter ID Registration
12. INSPECT TIRE PRESSURE WARNING SYSTEM
NOTICE:
If the tire pressure warning ECU is replaced, inspect the tire pressure warning system Test Mode Procedure
13. INITIALIZE TIRE PRESSURE WARNING SYSTEM
NOTICE:
* Be sure to register the transmitter IDs of all tires in the ECU before initialization.
* Be sure to inflate all tires to the proper inflation pressure before initialization.
HINT
Initialization
14. REGISTER IMMOBILISER COMMUNICATION ID
NOTICE:
If the ECM is replaced, register the ECU communication ID for the immobiliser system Engine Immobiliser System (W/ Smart Key System) w/ Smart Key System, Engine Immobiliser System (W/O Smart Key System) w/o Smart Key System).
15. PERFORM INITIALIZATION
NOTICE:
If the ECM is replaced, perform RESET MEMORY (AT initialization) Programming and Relearning