Installation

POWER STEERING: POWER STEERING ECU: INSTALLATION

1. INSTALL POWER STEERING ECU ASSEMBLY

(a) Install the power steering ECU assembly with the 3 nuts.





Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

(b) Check that the connector lever is at the fully unlocked position before installation.





NOTICE:
If the lever has been lifted out of the fully unlocked position, it may cause a faulty connection.

(c) Connect the 4 connectors to the power steering ECU assembly.





(d) Lightly pull on the connector and check that the connector does not disconnect.

2. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Connect the connectors to the back of the instrument panel junction block assembly.

(b) Engage the wire harness clamp onto the instrument panel junction block assembly.





(c) Install the instrument panel junction block assembly with the 3 nuts.





Torque : 8.4 Nm (86 kgf-cm, 74 in-lbf)

(d) Connect the connectors to the instrument panel junction block assembly.

(e) Engage the wire harness clamp onto the instrument panel junction block assembly.

3. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation

4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) Installation

5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) Installation

6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

7. INSTALL FRONT DOOR SCUFF PLATE LH Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

9. INSPECT SRS WARNING LIGHT

HINT
Diagnosis System