Installation
WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS: INSTALLATION
1. INSTALL QUARTER WINDOW ASSEMBLY
(a) Using a brush or sponge, apply Primer M to the exposed part of the vehicle body.
Standard measurement:
NOTICE:
* Apply Primer M in front of the bead as shown in the illustration.
* Allow the primer to dry for 3 minutes or more.
* Throw away any leftover Primer M.
* Do not apply too much primer.
(b) Using a brush or sponge, apply Primer G to the contact surface of the glass.
Standard measurement:
HINT
If the primer is applied to an area that is specified, wipe off the primer with a non-residue solvent before it dries.
NOTICE:
* To prevent the glass from breaking at low temperatures, ensure that no primer adheres to the contact surface between the moulding and glass during application.
* Allow the primer to dry for 3 minutes or more.
* Throw away any leftover Primer G.
* Do not apply too much primer.
(c) Apply adhesive to the quarter window assembly.
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
(1) Cut off the tip of the cartridge nozzle as shown in the illustration.
Standard measurement:
HINT
After cutting off the tip, use all the adhesive within the time written in the table below.
Usage time frame:
(2) Load the sealer gun with the cartridge.
(3) Apply adhesive to the quarter window glass as shown in the illustration.
(d) Install the quarter window glass to the vehicle body.
(1) Hold the quarter window assembly in place securely with protective tape or equivalent until the adhesive hardens.
NOTICE:
* Allow the primer to dry for 3 minutes or more.
* Check that the clips are attached to the body correctly.
* Check the clearance between the body and glass.
(2) Lightly press the outer surface of the glass to ensure a close fit.
(3) Using a scraper, remove any excess or protruding adhesive.
HINT
Apply adhesive onto the glass rim.
NOTICE:
Do not drive the vehicle within the time written in the table below.
Minimum time:
2. INSPECT FOR LEAK AND REPAIR
(a) Conduct a leak test after the adhesive has completely hardened.
(b) Seal any leaks with auto glass sealer.
3. INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof) Installation
4. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) Installation
5. INSTALL VISOR HOLDER Installation
6. INSTALL SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof) Installation
7. INSTALL ROOF HEADLINING TRIM CLIP STOPPER Installation
8. INSTALL ASSIST GRIP ASSEMBLY (w/ Sliding Roof) Installation
9. INSTALL REAR ASSIST GRIP SUB-ASSEMBLY (w/o Sliding Roof) Installation
10. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/o Sliding Roof) Installation
11. INSTALL TELEVISION DISPLAY ASSEMBLY (w/ Rear Seat Entertainment System) Installation
12. INSTALL TELEVISION BASE (w/ Rear Seat Entertainment System) Installation
13. INSTALL NO. 2 ROOM LIGHT ASSEMBLY Installation
14. INSTALL NO. 1 ROOM LIGHT ASSEMBLY (for Standard) Installation
15. INSTALL NO. 1 ROOM LIGHT ASSEMBLY (for Independent Type) Installation
16. INSTALL INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror) Installation
17. INSTALL VISOR ASSEMBLY LH Installation
18. INSTALL VISOR BRACKET COVER (for LH Side) Installation
19. INSTALL VISOR ASSEMBLY RH
HINT
Use the same procedure for the RH side and the LH side.
20. INSTALL VISOR BRACKET COVER (for RH Side)
HINT
Use the same procedure for the RH side and the LH side.
21. INSTALL ROOF CONSOLE BOX ASSEMBLY Installation
22. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH (w/o Power Back Door) Installation
23. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH (w/ Power Back Door) Installation
24. INSTALL QUARTER PILLAR GARNISH LH Installation
25. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Installation
26. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH Installation
27. INSTALL FRONT DECK SIDE TRIM COVER LH Installation
28. INSTALL NO. 2 DECK SIDE TRIM HOOK Installation
29. INSTALL ROPE HOOK ASSEMBLY (for LH Side) Installation
30. INSTALL REAR DECK TRIM COVER (w/o Remote Folding Function) Installation
31. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL LH (w/ Remote Folding Function) Installation
32. INSTALL REAR POWER OUTLET SOCKET COVER Installation
33. INSTALL REAR POWER POINT SOCKET ASSEMBLY Installation
34. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH Installation
35. INSTALL SIDE TRIM COVER LH (w/o Rear Seat Entertainment System) Installation
36. INSTALL POWER OUTLET SOCKET BEZEL (w/ Rear Seat Entertainment System) Installation
37. INSTALL DECK SIDE TRIM LH Installation
38. INSTALL DECK SIDE TRIM COVER LH Installation
39. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH (w/o Rear No. 2 Seat)
HINT
Use the same procedure for the RH side and the LH side.
40. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH (w/ Rear No. 2 Seat)
HINT
Use the same procedure for the RH side and the LH side.
41. INSTALL QUARTER PILLAR GARNISH RH
HINT
Use the same procedure for the RH side and the LH side.
42. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation
43. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
HINT
Use the same procedure for the RH side and the LH side.
44. INSTALL FRONT DECK SIDE TRIM COVER RH
HINT
Use the same procedure for the RH side and the LH side.
45. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
HINT
Use the same procedure for the No. 1 luggage compartment trim hook and the No. 2 deck side trim hook.
46. INSTALL ROPE HOOK ASSEMBLY (for RH Side)
HINT
Use the same procedure for the RH side and the LH side.
47. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH Installation
48. INSTALL REAR ROOM TEMPERATURE SENSOR (w/ Rear Automatic Air Conditioning System) Installation
49. INSTALL SIDE TRIM COVER RH (w/o Rear Automatic Air Conditioning System) Installation
50. INSTALL DECK SIDE TRIM RH
HINT
Use the same procedure for the RH side and the LH side.
51. INSTALL DECK SIDE TRIM COVER RH
HINT
Use the same procedure for the RH side and the LH side.
52. INSTALL REAR SEAT SIDE GARNISH CAP (w/o Rear Air Conditioning System) Installation
53. INSTALL REAR SEAT SIDE GARNISH CAP (w/ Rear Air Conditioning System) Installation
54. INSTALL REAR FLOOR FINISH PLATE Installation
55. INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat) Installation
56. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH (w/ Rear No. 2 Seat) Installation
57. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH (w/ Rear No. 2 Seat) Installation
58. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY (w/ Rear No. 2 Seat) Installation
59. INSTALL DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat) Installation
60. INSTALL REAR MAT Installation
61. INSTALL DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat) Installation
62. INSTALL DECK SIDE TRIM BOX LH Installation
63. INSTALL REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat) Installation
64. INSTALL DECK SIDE TRIM BOX RH Installation
65. INSTALL JACK CARRIER ASSEMBLY Installation
66. INSTALL JACK ASSEMBLY Installation
67. INSTALL JACK CARRIER CUSHION Installation
68. INSTALL JACK CARRIER SUPPORT
69. INSTALL REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat) Installation
70. INSTALL REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat) Installation
71. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
72. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY Installation
73. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY Installation
74. INSTALL DECK BOARD ASSEMBLY Installation
75. INSTALL CENTER PILLAR GARNISH LH Installation
76. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation
77. INSTALL LOWER CENTER PILLAR GARNISH LH Installation
78. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
79. INSTALL REAR DOOR SCUFF PLATE LH Installation
80. INSTALL FRONT PILLAR GARNISH LH Installation
81. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
82. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
83. INSTALL FRONT DOOR SCUFF PLATE LH Installation
84. INSTALL CENTER PILLAR GARNISH RH
HINT
Use the same procedure for the RH side and the LH side.
85. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
HINT
Use the same procedure for the RH side and the LH side.
86. INSTALL LOWER CENTER PILLAR GARNISH RH
HINT
Use the same procedure for the RH side and the LH side.
87. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
88. INSTALL REAR DOOR SCUFF PLATE RH
HINT
Use the same procedure for the RH side and the LH side.
89. INSTALL FRONT PILLAR GARNISH RH Installation
90. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation
91. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT
Use the same procedure for the RH side and the LH side.
92. INSTALL FRONT DOOR SCUFF PLATE RH
HINT
Use the same procedure for the RH side and the LH side.
93. INSTALL REAR NO. 1 SEAT ASSEMBLY LH Installation
94. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY LH (w/ Remote Folding Function) Installation
95. INSPECT REAR SEAT SLIDE ADJUSTER LOCK (for LH Side) Installation
96. INSTALL REAR SEAT LEG SIDE COVER LH Installation
97. INSTALL REAR INNER TRACK BRACKET COVER LH Installation
98. INSTALL REAR OUTER TRACK BRACKET COVER LH Installation
99. INSTALL REAR SEAT TRACK BRACKET COVER Installation
100. INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side)
101. INSTALL REAR CENTER SEAT ASSEMBLY
102. INSTALL REAR NO. 1 SEAT ASSEMBLY RH Installation
103. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY RH (w/ Remote Folding Function)
HINT
Use the same procedure for the RH side and the LH side.
104. INSPECT REAR SEAT SLIDE ADJUSTER LOCK (for RH Side) Installation
105. INSTALL REAR SEAT LEG SIDE COVER RH Installation
106. INSTALL REAR INNER TRACK BRACKET COVER RH Installation
107. INSTALL REAR OUTER TRACK BRACKET COVER RH Installation
108. INSTALL REAR SEAT TRACK BRACKET COVER Installation
109. INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side)