Installation

WINDSHIELD / WINDOWGLASS: POWER WINDOW REGULATOR MOTOR: INSTALLATION

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Door)

NOTICE:
The regulator arm must be below the intermediate position when installing the front power window regulator motor assembly.

(a) Using a "TORX" driver (T25), install the front power window regulator motor sub-assembly with the 3 screws.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

HINT
A new rear window regulator uses self-tapping screws to thread new installation holes.

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (for Front Door) Reassembly

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY (for Front Door) Reassembly

4. INSTALL FRONT DOOR SERVICE HOLE COVER (for Front Door) Reassembly

5. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP (for Front Door) Reassembly

6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Front Door) Reassembly

7. INSTALL COURTESY LIGHT ASSEMBLY (for Front Door) Reassembly

8. INSTALL ASSIST GRIP COVER (for Front Door) Reassembly

9. INSTALL FRONT ARMREST UPPER BASE PANEL (for Front Door) Reassembly

10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG (for Front Door) Reassembly

11. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (for Front Door) Reassembly

12. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear Door)

NOTICE:
The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.

(a) Using a "TORX" driver (T25), install the rear power window regulator motor assembly with the 3 screws.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

HINT
A new rear window regulator uses self-tapping screws to thread new installation holes.

(b) Connect a positive (+) lead of the battery to terminal 1, and a negative (-) lead to terminal 2 of the rear power window regulator motor assembly to move the lift arm to the position shown in the illustration.





13. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (for Rear Door) Reassembly

14. INSTALL REAR DOOR GLASS SUB-ASSEMBLY (for Rear Door) Reassembly

15. INSTALL REAR DOOR QUARTER WINDOW GLASS (for Rear Door) Reassembly

16. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY (for Rear Door) Reassembly

17. INSTALL REAR DOOR GLASS RUN (for Rear Door) Reassembly

18. INSTALL REAR DOOR WEATHERSTRIP (for Rear Door)

(a) Install the front door weatherstrip.

19. INSTALL REAR DOOR SERVICE HOLE COVER (for Rear Door) Reassembly

20. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP (for Rear Door) Reassembly

21. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY (for Rear Door) Reassembly

22. INSTALL DOOR ASSIST GRIP COVER (for Rear Door) Reassembly

23. INSTALL REAR DOOR ARMREST UPPER BASE PANEL (for Rear Door) Reassembly

24. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG (for Rear Door) Reassembly

25. CONNECT NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

26. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side)

Initialization