Parking Brake Switch Circuit

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Parking Brake Switch Circuit
- Parking Brake Switch Circuit

DESCRIPTION

This circuit includes the parking brake switch and navigation receiver assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK PARKING BRAKE SWITCH ASSEMBLY (DISPLAY CHECK MODE)

(a) Enter the "Display Check" mode and select "Vehicle Signal Check" Operation Check.





(b) Check that the display changes between ON and OFF according to the parking brake operation.

OK





HINT
This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.

NG -- CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)

(a) Disconnect the G18 navigation receiver assembly connector.

(b) Disconnect the A2 parking brake switch assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. INSPECT PARKING BRAKE SWITCH ASSEMBLY

(a) Remove the parking brake switch assembly Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE PARKING BRAKE SWITCH ASSEMBLY Removal

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures